How to Use the RYOBI Whole Stud Detector

By RYOBI Nation

SKILL
easy

The RYOBI Whole Stud Detector (ESF5002) is designed with multiple LED's to indicate the full width of the stud, not just an edge or center. The one-handed operation provides an easy to use experience every time. The Auto Depth Scan Technology determines the thickness of the wall up to 1-1/2" thick to accurately identify wood and metal studs.

Tools

  • Whole Stud Detector

Steps

STEP 1

Press and hold the power button on the side of the tool, making sure to place the hand below the indicated line shown on the tool.

Tools

Whole Stud Detector
press and hold side button

STEP 2

Continue to hold down the power button and the LED lights will flash to indicate that the tool is calibrated.

Tools

Whole Stud Detector
hold down the power button

STEP 3

Continue to hold the power button and move the tool slowly across the surface. Once a stud is found, all the LED lights will illuminate.

Tools

Whole Stud Detector
slowly moving tool across wall

STEP 4

Once the stud is found press the button to mark where the stud is.

Tools

Whole Stud Detector
Marking stud

TIP #1

If the LED lights calibrate, but no lights appear when it is moved, move the device and calibrate again.

Tools

Whole Stud Detector
troubleshooting whole stud detector

Tip #2

If the LED lights flash repeatedly, move the device and calibrate the LED lights again.

Tools

Whole Stud Finder
re-calibrating device