Steps
Step 1
Use the 25 FT. Tape Measure to mark the leather at 3/4 depth to make leather strips. Use the USB Lithium Power Cutter to cut a straight line in the leather.
Tools
Power Cutter
Materials
Leather Sheet
Step 2
Cut out letters that will be traced with the Quick Change Hobby Knife. Attach the letters to tracing paper. Fold the leather in half, then place the tracing paper in the middle. Outline the letters with a pencil.
Tools
Hobby Knife
Materials
Pencil, Tracing Paper
Step 3
Insert the Ball Engraving Burr into the Rotary Tool. Carefully engrave the letters using the Rotary Tool.
Tools
Engraving Burr, Rotary Tool
Materials
Leather Sheet
Step 4
Switch the rotary accessory to the 1/8" Drill Bit. Fold the leather in half. Drill a hole a 1/4 inch down, going through both sides so they line up.
Tools
1/8" Drill Bit, Rotary Tool
Materials
Leather Sheet
Step 5
Slide the key ring onto the leather strap. Attach the rivet into the holes made in the previous step and press together.
Materials
Key Ring, Rivet
