Wooden Geometric Wreath

By RYOBI Nation

SKILL
intermediate

Display your love for woodworking this holiday season. Whether it is on your front door or another place of distinction, this wreath offers the warmth of wood or can be customized with your favorite finishes and paint techniques. While I used oak hobby boards, you could definitely use inexpensive materials like pre-cut shims. Created by Deeply Southern Home

Tools

  • 18V ONE+ HP Brushless 8-1/4" Table Saw
  • 18V ONE+ HP Brushless 1/2" Drill/Driver
  • 18V ONE+ HP Brushless Air Strike 18 GA Brad Nailer

Materials

  • (3) 1/4"x6' Boards
  • Angle Measure Tool
  • Clamps
  • Wood Filler

Steps

STEP 1

Using oak hobby board panels (1/4x6-3ft) rip with a table saw (or cut with a circular saw), strips 1 1/2 inches wide.

cutting wood strips

STEP 2

Trim strips into 11 3/4 and 9 3/4 long pieces. 12 of each.

Tools

Circular saw
Trimming wood strips

STEP 3

Lightly sand strips before assembling.

Sanding strips

STEP 4

Arrange strips of smaller, 9 3/4 pieces into a hexagon shape. Make 2 of these.

arranging wood strips

STEP 5

Use angle measure tool/guide or printed template to fairly accurately align corners. A regular hexagon like this one has corners that are 120 degrees. They don't have to be perfect, but getting the corners fairly close helps with the symmetry.

angling wood pieces

STEP 6

Wood glue overlapping wood slats to secure pieces together. Use small clamps if possible. (Not required.)

STEP 7

Once the hexagons are dry. Stack small hexagons one on top of the other, rotating the top hexagon about 45 degrees.

Stacking hexagons

STEP 8

Add small scraps of wood as lifts to provide extra support where the layered hexagons do not touch because of the overlapping pieces. Add wood glue to all pieces that touch.

Adding wood supports

STEP 9

Using a brad nailer or staple gun, secure the two hexagons together where the thickest parts of the overlapping wood meet and/or where the scrap wood lifts were placed.

STEP 10

Fill nail or staple holes with wood filler.

Filling nail holes

STEP 11

Repeat steps 5-10 for the large hexagons.

Creating hexagon shapes

STEP 12

Then attach the small hexagons on top of the larger hexagons, rotating as before. Attach with glue and nails or staples. Fill holes with wood filler.

Assembling hexagons

STEP 13

Attach a picture hanger to the back of the wreath. Pre-drill hole and carefully attach with a screw. Be conscious of hook placement as the screw may go through one layer of the wood.

Tools

Drill/Driver
Attaching picture hanger

STEP 14

Apply desired finish. Because I used this beautiful oak wood, I decided to just add a clear satin finish suitable for outdoors. Feel free to be creative with your finishing, layer with different colors of finishes in advance or paint as desired.

applying finish